橡胶注射成型机的保养
Maintenance of rubber injection molding machine
电路：注意电路板清洁，定时清理强弱电箱灰尘，保持电箱干爽，防止受潮。
Circuit: pay attention to the cleaning of the circuit board, regularly clean the dust in the strong and weak electric boxes, keep the electric boxes dry and dry, and prevent moisture.
油路：检查油路各部位有无漏油现象，及时处理。防止活塞杆刮伤和油质变质。
Oil circuit: check all parts of the oil circuit for oil leakage and deal with it in time. Prevent the piston rod from scratching and oil deterioration.
机械：机台传动部位检查有无磨损现象，检查每个黄油嘴有无堵死现象，并注黄油。
Mechanical: check the transmission part of the machine for wear, check whether each grease fitting is blocked, and inject grease.
其他注意事项：液压油建议一年更换一形骨架模具 保定代理记账 保定道闸 防撞护栏模具 风电基础模具 保定空压机 北京真空泵次并清理油箱油泥，水冷却器及时清理防止油温上涨造成油质加速老化，当然安全无小事，电路安全门开关，油路泄压阀，机械安全挡块，机台警示灯在保养的时候一定要检查是否正常工作.
Other precautions: it is recommended to replace the hydraulic oil once a year and clean the oil sludge in the oil tank. The water cooler should be cleaned in time to prevent the oil temperature from rising and causing the accelerated aging of the oil quality. Of course, there is no small matter about the safety. The circuit safety door switch, oil way relief valve, mechanical safety stop and the warning light of the machine must be checked for normal operation when maintaining