全自动免烧成型机使用安全规则 |
添加时间:2022/8/2 15:00:32 浏览次数: |
全自动免烧成型机使用安全规则 Safety rules for use of automatic non burning molding machine 1.该机操作人员必须认真掌握说明书内容,弄清机器构造,电器控制,否则不得上岗操作和维修。 1. The operator of the machine must carefully grasp the contents of the manual, make clear the machine structure and electrical control, otherwise, they are not allowed to work for operation and maintenance. 2.进行机器检查,清理之前必须切断电源。 2. Check the machine and cut off the power supply before cleaning. 3.在清理和检修模箱时,应将压头横梁吊钩挂好,防止误动使压头落下伤人。当模箱加料时,不允许将压头横梁任意脱钩自由下落,否则将损坏设备。长期不用或运输本机时,宜将压头横梁随模箱落至振动台上。 3. When cleaning and repairing the mold box, hang the hook of the head beam to prevent the pressure head from falling down and injuring people. When the die box is fed, the crossbeam of the head is not allowed to be uncoupling freely, otherwise the equipment will be damaged. When the machine is not used or transported for a long time, the ram beam should be dropped onto the vibration table along with the mold box. 4.接通电源后,操作人员要明确自己的职责,按操作规程认真操作,非工作人员不得靠近机器。 4. After switching on the power supply, t铜钟 一次性止血带 标志桩模具 钢丝轮 流水槽模具 防撞墙模具 检查井钢模具 不锈钢铸件 模锻件he operator should be clear about his / her responsibilities and operate carefully according to the operation regulations. Non staff should not be close to the machine. 5.操作人员操作前应检查机器各运动部件是否处于起始状态,特别是加料小车是否在贮料斗下受料(每天应多次检查并拧紧螺丝,以免螺丝松脱,损坏设备。由于该机型振动力大,当焊接部位震开后应及时修复,部件错位的,应及时修正。 5. Before operation, the operator should check whether all moving parts of the machine are in the initial state, especially whether the feeding trolley is receiving materials under the hopper (check and tighten the screws several times a day to prevent the screws from loosening and damaging the equipment). Due to the large vibration force of the machine, it should be repaired in time when the welding parts are shaken open. If the parts are misplaced, they should be corrected in tim |
上一页 平板在整个硫化过程中 |
下一页 橡胶注射机的主要特点 |
Copyright © 技术支持:遨游网络